RE: [DMCForum] Need a bearing..

["timnagin" <timnagin@xxxxxxxxxxxxxx>]

No problem; glad to help if I can.  I am still waiting on a return call from
another company so we will see what comes of that.  I wasn't sure of the
exact application so yea, stacking wouldn't work.  One place stated you
could have the bearing made, but they would have to do a run of several
pieces and that would get into some money.

Have you looked into an internal setup that eliminates the bearing like what
is used on the GM 6-speed?

Greg



-----Original Message-----
From: Marc Levy [mailto:malevy_nj@xxxxxxxxx]
Sent: Monday, April 04, 2005 5:41 PM
To: DMCForum@xxxxxxxxxxxxxxx
Subject: RE: [DMCForum] Need a bearing..



Stack?  I don't think that is possible for this
application.

The is for the pilot bearing, and there is about 1/2
inch gap between the end of the input shaft and the
crankshaft.

I am left with 2 other options..  Make a hub to bring
the bearing out to reach the input shaft, or have the
input shaft extended (or make a new one).

Both seem like expensive options.  :(

Thanks for checking Greg.. I appreciate it!


--- timnagin <timnagin@xxxxxxxxxxxxxx> wrote:
>
> I called a few places here that specialize in this
> and they didn't have
> anything that wide.  Several suggested stacking
> three 17 x 35 x 10 together
> and using a bronze bushing to fill in some of that
> space, if you can.  The
> largest they could find was a 17 x 35 x 14.
>
> Greg

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.