RE: [DMCForum] Need a bearing..

[Marc Levy <malevy_nj@xxxxxxxxx>]

Stack?  I don't think that is possible for this
application.
 
The is for the pilot bearing, and there is about 1/2
inch gap between the end of the input shaft and the
crankshaft.

I am left with 2 other options..  Make a hub to bring
the bearing out to reach the input shaft, or have the
input shaft extended (or make a new one).

Both seem like expensive options.  :(

Thanks for checking Greg.. I appreciate it!

 
--- timnagin <timnagin@xxxxxxxxxxxxxx> wrote:
> 
> I called a few places here that specialize in this
> and they didn't have
> anything that wide.  Several suggested stacking
> three 17 x 35 x 10 together
> and using a bronze bushing to fill in some of that
> space, if you can.  The
> largest they could find was a 17 x 35 x 14.
> 
> Greg
>


            
__________________________________ 
Yahoo! Messenger 
Show us what our next emoticon should look like. Join the fun. 
http://www.advision.webevents.yahoo.com/emoticontest

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.