RE: [DMCForum] Replacing Door/Roof Seals
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [DMCForum] Replacing Door/Roof Seals



Drill the rivets our carefully. Make sure you put something to protect the
torsion bar.

Unfortunately, the drill is the only way to go.

-----Original Message-----
From: Michael Babb [mailto:mcbabb@xxxxxxxxx]
Sent: Tuesday, March 29, 2005 4:23 PM
To: dmcnews@xxxxxxxxxxxxxxx
Cc: DMCForum@xxxxxxxxxxxxxxx
Subject: [DMCForum] Replacing Door/Roof Seals



Hey gang,

I am looking at replacing the weather seals that mount to the uppermost
part of the door and form the seal between the door and the T-panel.
These are held in with pop rivets.

Questions:

How the heck do you get these pop rivets out? I was looking at them with
the drill, but the fear of nicking the torsion bar with a drill bit made
me hold of on this route . .  .

Once you get the rivets out and are ready to mount the new parts, do
people usually just screw these in, or are pop-rivets the way to go . .
.don't want to have to go through too much pain if I have to do this
again in the future.

Michael & 3472






Yahoo! Groups Links







Yahoo! Groups Sponsor
ADVERTISEMENT
click here


Yahoo! Groups Links



Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated