[DMCForum] Water pump and internal water pipe removal

["usndmc" <usndmc@xxxxxxxxx>]

I am in the process of replacing my all-original cooling system. I
have been soaking the bolts for the water pipe and water pump with
penetrating oil for a few days. Tomorrow morning I am going to get a
propane torch for heating the bolts before removing. I don't have much
experience with this sort of thing and was just looking for any tips
or advice on how to remove these bolts without breaking them. Also, if
they do happen to break, I've heard it's a real pain to drill them
out. Never done that before either...any helpful pointers on the
entire process would be greatly appreciated! Also, is there a way to 
test the idle speed thermistor while you have the system taken apart 
to see for sure that it is good? Thanks everyone and Happy
upcoming New Year!

Dave
#5968

---

YAHOO! GROUPS LINKS

•  Visit your group "DMCForum" on the web.
   
•  To unsubscribe from this group, send an email to:
   DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
•  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---