[doc] Torque Settings.... ????

["Mike Bosworth" <mike.bosworth@xxxxxxxxxxxxxx>]

Hiya All

As a winter project and seeing as my radiator is weeping, its time 
for a 'coolant refurb', ive started to clean out all the kit on top 
of my 'valley of death'  All looks fine in there except for the 24 
years of dirt and grime , BTW the two square holes in the top side 
of the engine block, are just dying to 'rot' through but apart from 
filled with 4" of crap thankfully mine are still intact.

(Maybe everyone needs to be looking in there folks, yes i know its 
quite a lenghty job :)  ) 

Going to replace my water pump and all hoses, o rings, vaccumm lines 
etc whilst im in there.


If like me you have the origional pump and hoses etc they really 
need to be looked at as even thou my car came from a warm dry state 
and still look like they are well well past their best.

Heres the question:-

Does any one know the following torque settings for these bolts?.

Water pump bolts to engine block?
Back of pump / pump back bolts?
Water Y pipe to engine block?
Intake Manifold to engine ?

Thanks

Mike
#2001
And a bedroom full of grubby, petrol smelling parts :)






DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **

Yahoo! Groups Sponsor

Get unlimited calls to

U.S./Canada

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/doc-uk/
   
• To unsubscribe from this group, send an email to:
  doc-uk-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.