Re: Pivot Bolts

["dmcman82" <srubano@xxxx>]

If you hammer them out make sure you put the Nuts on them partially, 
enough that the end of the bolt and the flat surface of the nut are 
flush. This will prevent you from ruining the threads on the bolt 
when you tap it out with the hammer.

Steve

--- In dmcnews@xxxx, "Paul Salsbury" <paul.salsbury@xxxx> wrote:
> Hi all
> 
> I am trying to remove my rear hub carrier and have come across a 
small hurdle, the Pivot bolts..
> 
> I have taken the nuts off the end of the pivot bolts, however they 
just won't come out. Does the Split spacer (100481) grip them in any 
way? 
> 
> Is it just a case of hitting them hard with a hammer to get them 
out?
> 
> Also is there an easy way of un-doing the Bolts between the inner 
and outer drive shafts?
> 
> Cheers
> 
> Paul
> #6463
> 
> 
> [Non-text portions of this message have been removed]