Re: [DMCForum] Removal of Timing Pulley
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DMCForum] Removal of Timing Pulley



Thanks,

35 mm is 1.378, or just .003 larger than 1 3/8", which is what I used.  
I found a nice 6 point socket at McMaster Carr, the socket I was using 
was 12 point.  Still don't know if when I'm loosening the Nut if I'm 
really tightening it (is it left hand or right hand thread).  
Frustrating when you have a 1 3/8" socket on a 3/4" drive and a breaker 
bar, and still can't get if loosened.

Paul



delorean wrote:
> 35 MM if I remember correctly. Some say it is a 36 mm but a 36 is  
> loose, 35 mm is snug. Apply lots of heat to get the bolt off.
>
> Mark V
>
>   


------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/DMCForum/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/DMCForum/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:DMCForum-digest@xxxxxxxxxxxxxxx 
    mailto:DMCForum-fullfeatured@xxxxxxxxxxxxxxx

<*> To unsubscribe from this group, send an email to:
    DMCForum-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/



Home Back to the Home of PROJECT VIXEN


Copyright 2006 ProjectVixen.com.  All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive