[DMCForum] Re: A simple task
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[DMCForum] Re: A simple task



Been there done that.

I tighten my lug nuts to the manual spec by hand with a torque
wrench. They end up siezed anyway, probably because the car is
stored outside (gasp!)


--- In DMCForum@xxxxxxxxxxxxxxx, "Joe OBrien" <joeyoseppijoe@xxxx>
wrote:
> What about a breaker bar, and an eight foot cheater pipe? I
haven't
> found a lug nut anywhere that can survive the monster chater pipe.
>
> Thankfully, I have never had to use it on a D because I always
> tighten my own lugs by hand, er, breaker bar.
>
>
> -Joe
>
>
>
> --- In DMCForum@xxxxxxxxxxxxxxx, "cruznmd" <racuti1@xxxx> wrote:
> > It is true, dealer mechanics are no better, simply because they
> > refuse to follow manuals or procedures just as you said.
> >
> > I own factory manuals on all of my vehicles now, no matter how
new
> > or old.
> >
> > The only reason I went to this a-hole in the first place was
> because
> > my own pneumatic impact gun wasn't strong enough. I knew the
shop
> > would have a 600 ft/lb. gun.
> >
> > Rich
> >
> > --- In DMCForum@xxxxxxxxxxxxxxx, Marc Levy <malevy_nj@xxxx>
wrote:
> > > I made this discovery many years ago..  Which forced
> > > me to take on more jobs on my car than I would have
> > > otherwise.  The process too a long time, but I
> > > remember the exact moment I made the decision.
> > >
> > > It was my Chevy Beretta.  One day on the way home, the
> > > clutch went out. I had never done a front wheel drive
> > > clutch before (heck, I had never done *ANY* clutch
> > > before, but was always told FWD was VERY difficult) so
> > > I took it to a reputable transmission shop. 
> > >
> > > A week later (I was told the job would take 1 day) I
> > > went to pick it up..  An extra $100 was added to the
> > > bill for some bullshit thing they claimed they needed
> > > to fix "while they were there". 
> > >
> > > So, I pay my bill.. Get in the car, and drive off..
> > > First bump I hit, I hear a loud noise.  Turn around,
> > > go back.  They put it up on the lift, and the problem
> > > was obvious.  The washer on the anti-sway bar was
> > > broken.  They took it apart, and replaced it.  As they
> > > put it back together they used the impact gun.  I
> > > stopped the guy, and explained to him that THIS is why
> > > he broke it in the first place! 
> > >
> > > While the car was in the air, I then noticed that the
> > > CV boot had slid off of the outer CV joint.  I asked
> > > the mechanic if he had properly supported the axle
> > > when the transmission was out.  He gave me a puzzled
> > > look and called the boss out.  I then had to take out
> > > my factory service manual to show them how the axle is
> > > supposed to be supported.  He told me "Professional
> > > mechanics don't need the manual"..
> > >
> > > Either way, I told him he was going to need to fix the
> > > boot.  He agreed, and told me to come back later in
> > > the week when he had the part in.
> > >
> > > <Skipping some boring details>
> > >
> > > When the went to put the car back together, out comes
> > > the impact gun again.  He puts on the axle nut with
> > > the gun as I am yelling at him to stop!!  I said "You
> > > need to use a torque wrench.  If you don't know the
> > > specification, I will look it up for you".  He
> > > responded "The gun will make it tight enough, it wont
> > > fall off".  So, I had to try and explain to this
> > > "Professional" the TOO Much force would crush the hub
> > > bearing...  After some arguing, he went off to find a
> > > torque wrench.  It took about 20 min for them to find
> > > one.
> > >
> > > Just one of many stories about lazy/stupid
> > > mechanics... An no, Dealerships are no better.
> > >
> > > Funny thing is, by the time I had my DeLorean I was
> > > pretty confident in my ability to work on cars.  My
> > > attitude was that I could do no worse than a
> > > "professional".  At least I knew how to read the
> > > service manuals. 
> > >
> > > When I bought my DeLorean, I had so much trust in Rob
> > > Grady that I would always bring my car to him.  My
> > > thought was, I had all of my other cars to work on I
> > > might as well use a trusted mechanic whenever
> > > possible....  But there is SO much traffic on Long
> > > Island!  ROB, MOVE TO JERSEY!!  :)
> > >
> > >
> > >
> > > --- cruznmd <racuti1@xxxx> wrote:
> > >
> > > > In my life no matter where I've lived or what
> > > > vehicle I've owned at
> > > > the time, from my 1964 IH Scout, to my 2 Chevy
> > > > Trackers, to my 2002
> > > > PT Cruiser and including my DeLorean, EVERY single
> > > > "professional"
> > > > ASE certified mechanic has caused more damage to my
> > > > vehicle than
> > > > repair.
> > > >
> > > > So why do I continue to go there? Because I'm an
> > > > idiot. I keep
> > > > thinking "they can't all be this incompetent."
> > > >
> > > > A smiple task, To wit;
> > > >
> > > > Sir, I have two lugnuts on my DeLorean that have
> > > > become too tight
> > > > for me to break loose. Can you put your impact gun
> > > > on them for
> > > > me? "Sure" he says. The guy spins them loose and
> > > > promptly
> > > > overtightens them with the pneumatic impact gun. I
> > > > now have one
> > > > stripped lugnut that I can't get off.
> > > >
> > > > I do solemnly swear that I will never trust a gas
> > > > station mechanic
> > > > again as long as I live.
> > > >
> > > > Rich A.
> > > > #5335
> > >
> > >
> > > __________________________________________________
> > > Do You Yahoo!?
> > > Tired of spam?  Yahoo! Mail has the best spam protection
around
> > > http://mail.yahoo.com




YAHOO! GROUPS LINKS






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated