[DMCForum] Clutch / Roll pin Replacement

[Michael Paine <mpaine@xxxxxxxxxxxxxxxx>]

Hey all

First post... it's a request for help...

I need to replace the roll pin for the 1st & 2nd gear shift fork. I also need to
replace the clutch... Might as well do the trailing arm bolts while in there too.

I have 2 jack stands and a 3 ton floor jack... No garage, but a flat driveway. I
CAN get access for a day to a bay of a "garage" that has a lift. I can't leave
the car overnight - the lift will go up about 4 ft using long pads that raise on
both sides in the wheel base. I would be free to roll up or down the length of
the car in the center. 

What tools do I need to reace the clutch and where do I get the sealant for the
tranny case??

Help for a transmission noob...

Thanks,

Michael Paine
vin 6067

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.