[DMCForum] Re: Hunting grounds
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[DMCForum] Re: Hunting grounds



Rich,
if you don't wanna take off the T-Panel (which isn't really hard) then
try to get to the connectors for the doors inside the car.
Take off the board on the rear shelf and follow the harness.
Right behind the side cover (that covers the rear speaker ) there should
be a connector on each side. Pull it - and the door lights should be
disconnected.

If you ever installed the Wing-a-loft kit from Toby you should know what I'm
talking about.

Also take a look at the interior lamps because they have a ground line and a
feed line directly connected. Pull them out and see if they have melted or
the
plastic is broken somehow.

There is also a connector for the rear harness to the engine compartment
light.
Pull that connector - it is under the cover near the coil.

Don't forget the trunk light - it's on the same wire as the other lights.

And do yourself a favour and do NOT use a 30A fuse to toast your harness.
Use your multimeter and measure the resistance.(Does it have a beeper ? very
handy !)

The switches can't be the culprits - they are behind the bulbs so it doesn't
matter
when they are connected to ground - this is what they do themselves.

If it is NOT in the doors and not in the engine compartment - then I'd
suspect
the center console because there are the wires for the front dome light and
I
think also for the trunk light.

Elvis


Message: 14
   Date: Mon, 07 Feb 2005 03:21:24 -0000
   From: "cruznmd" <racuti1@xxxxxxxxxxxx>
Subject: Re: Hunting grounds (cough Greg cough)


--- In DMCForum@xxxxxxxxxxxxxxx, Marc Levy <malevy_nj@xxxx> wrote:

> If you know where the circuit splits, you could see
> which branch gets hot..

That's exactly what I'm asking. Where's the junction where all the
purple wires split off to their respective lights?

> Also, Did you just run your hand along the harness
> looking for any nicks or cuts?  Maybe a screw
> penetrated the harness somewhere.

I did. I found one rough spot that I patched up.

> I have not looked @ the schematics in a while, but
> recall the "hot" leg goes in to the doors, and the
> lights are switched by ground..  So, you could remove
> the T panel, and disconnect the wire harness for the
> doors.  This may isolate the problem so you know if it
> is in the doors or not.

I have been told to check the T-panel but I haven't gotten that far
and I've never pulled the panel. I'm nervous about doing it.

Rich A.



Yahoo! Groups Links



Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated