RE: [DMCForum] Re: Going keyless (push-button start) - Ryan...

["timnagin" <timnagin@xxxxxxxxxxxxxx>]

Ryan,

I don't remember seeing that but would like to know more about it.  Putting
a start button there wouldn't be that difficult at all.

If you find out more, please let me know.

Greg


-----Original Message-----
From: ryanpwright [mailto:yahoo1@xxxxxxxxxxxxxx]
Sent: Tuesday, December 21, 2004 11:08 PM
To: DMCForum@xxxxxxxxxxxxxxx
Subject: [DMCForum] Re: Going keyless (push-button start) - Ryan...




Greg, Andrei -

That's not what I was looking for. There was a post on the DML at
least 6-8 months back about someone who put a start button physically
in place of the ignition switch. I was hoping to find out where he got
the button, for ease of fit.

Actually I have more experience with automotive electrical than most.
My question wasn't in "how" to do this, but where to find that
specific button, and whether a relay was needed (I was concerned about
the amount of current running through the switch -- When I hooked up
the remote start on my alarm system, the specs called for an external
relay).

Now that I think about it, I could just tap a momentary switch into
that same relay. Hmph. ;)

Thanks for the replies.

-Ryan

--- In DMCForum@xxxxxxxxxxxxxxx, Andrei Cular <acular@xxxx> wrote:
> Thats the 3-rotor...  If you have Jim's email you can ask him about the
> button, but I believe it was just a switch that he had laying around
> that worked.
>
> Ryan get your self a wiring diagram and a book on basic automotive
> electrical.  Hooking up a start button in place of the key is a very
> simple operation, but if you have zero experience and no clue when it
> comes to automotive electrical systems you will get your self in to
> trouble really quick.
>
> Andrei
>
> timnagin wrote:
>
> >Ryan,
> >
> >Was this the link you were looking for?  Scroll down to the second
from the
> >last picture.
> >
> >http://www.eliseusa.com/rotary.htm
> >
> >Greg
> >
> >
> >
> >-----Original Message-----
> >
> >Yes, it's me again.
> >
> >I recall reading a post many months ago about someone who replaced his
> >ignition key with a push-button start. I specifically recall reading
> >that the button fit perfectly in that hole. My questions,
> >
> >1. Anyone know who this was?
> >2. Where'd the button come from?
> >3. Do you supply power to the starter directly through the button, or
> >is a relay used (and if so, any special type, or just a standard 12
> >volt sealed automotive relay)?
> >
> >Thank you,
> >
> >-Ryan

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.