[DMCForum] Re: The ongoing saga of clutch replacement

[tmpintnl@xxxxxxxxx]

Ryan - The torque spec for the flywheel to crankshaft bolts is 41 - 
45 ft-lbs (don't forget the loctite), and the clutch pressure plate 
to flywheel bolts are at 15 ft-lbs.  Also use loctite on the outside 
diameter of the pilot bearing into the crankshaft.  Careful to avoid 
getting the loctite into the bearing in any way.  The torque pattern 
for flywheel and pressure plate both is to cross over diametrically 
in even increments until tight.

My personal copy of the workshop manual is also photocopied, but may 
be a "first generation" copy as it is pretty good.  It too is a bit 
grimy ... in use since 1988.

Good job on those TOBY-TAB's!!!

Toby Peterson
DeLorean Parts Northwest, LLC
www.delorean-parts.com 


--- In DMCForum@xxxxxxxxxxxxxxx, "ryanpwright" <yahoo1@xxxx> wrote:
Still need to replace the Toby Tabs and ...
> 2. What are the torque specs & pattern on the flywheel bolts?

Yahoo! Groups Sponsor

Get unlimited calls to

U.S./Canada

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.