[DMCForum] Re: Marc's Mustang (1966)

["content22207" <brobertson@xxxxxxxxxxxx>]

Autozone sells a nice cap & rotor set from Conrad that uses brass
contacts, not aluminum. Very long wearing.

You're not burning points in that little 302, are you? If so, replace
them with Pertonix's electronic conversion ASAP. 100% guarantee it
will be the best money you've ever spent. Is a truly neat product --
bolts inside the distributor using the original point mounts. Runs off
full 12v (no resistor necessary). Couple it to a 40,000 or 45,000 volt
coil for the most bang from your buck -- total conversion cost $100 or so.

Bill Robertson
#5939

>--- In DMCForum@xxxxxxxxxxxxxxx, Marc Levy <malevy_nj@xxxx> wrote:
> 
> My 1966 Mustang needs new cap, and rotor every 2
> years.  True, easy to change.. but as they wear out it
> has an impact on the performance and fuel economy of
> the car..  The coil packs are consistent.
>

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.