[DMCForum] Re: A simple trick: New tech article on DMCForum.org

[tmpintnl@xxxxxxxxx]

Hi guys - I lurk, therefore I am.  I read Rich's article 
on "hotwiring" the cold start injector, and have a question to the 
general audience.  Would this work for temporary enrichment of the 
fuel/air mixture at wide open throttle?  Winged1 goes a bit lean at 
WOT, and I tried to richen things up a bit using the mixture screw.  
The bad thing is that I am too rich at idle then, and the Lambda 
system gets grumpy.  It would seem that a little extra shot 
(manually applied) would be a good thing for performance and to 
prevent that dreaded detonation that can happen at WOT in a slightly 
lean condition.  What thinkest thou?

Toby Peterson


--- In DMCForum@xxxxxxxxxxxxxxx, "cruznmd" <racuti1@xxxx> wrote:
> I've written a little article on how to wire up your cold-start 
valve 
> to prime your engine on-demand

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.