Re: [DMCForum] slave cylinder

[Martin Gutkowski <webmaster@xxxxxxxxxxxxxx>]

We had a similar experience and bought a portable pipe-flaring kit. Now 
in situations such as yours, it's a 5 minute job to make a new hard line 
out of copper pipe.

Best Wishes

Martin

cruznmd wrote:

>For the love of Christ!
>
>This is a horrible job. I've removed the fuel system for better 
>access. The heater system hoses are in the way and I'm not taking 
>them apart.
>
>The line fitting has rusted to the line. I found out today, that the 
>stainless braided line doesn't replace the entire line. It goes from 
>the hard line at the cylinder to the hard line at the clutch. It 
>doesn't replace the whole thing so it's not going to do me any good 
>(beyond replacing the icky plastic). I'm going to have to cut the 
>hard line, flare it and re-fit it.
>
>On top of that, I was flipping a fuel line out of my face, and I lost 
>my balance and yanked it right off of the banjo fitting!
>
>Once this crap is done, I hope nothing else goes wrong before the 
>Spring Social.
>
>Is anyone here going to that by-the-way?
>
>Rich A.
>#5335
>
>  
>

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.