Look in the service manual for the sensor specs. You can simulate any variable needed to test the sensors. For example, a good thermometer and a hot plate with a container of water. For vacuum snesors and HVAC work a tester like the Mityvac is a tool every car owner should have. Just duplicate what the engine would supply as temps and vacuum levels and monitor the sensor output with the appropriate measuring tool to see if it falls within the specs listed in the manual. This can be done with any sensor if you use a little creativity. If you are going to do your own work there are a few tools that are a must to own. The FI test kit, a good multimeter, Mityvac, and a decent vacuum gage come to mind. An AC manifold set and a cooling system tester are handy also. Learn each subsystem in the car seperately and go from there, these cars are very simple compared to a modern vehicle. Above all, study your service manual. >>There are 3 sensors attached to the water pipe under the intake and before i put the engine back together i want to make sure these sensors are operating correctly so how do i test each sensor to make sure it is operating correctly? I have a new vacuum sensor so i just need to know how to test the other 2 electric sensors.<< Yahoo! Groups Sponsor <http://rd.yahoo.com/M=251812.3170658.4537139.1261774/D=egroupweb/S=170512 6215:HM/A=1564415/R=0/*http://www.netflix.com/Default?mqso=60164784&partid =3170658> <http://us.adserver.yahoo.com/l?M=251812.3170658.4537139.1261774/D=egroupm ail/S=:HM/A=1564415/rand=487495490> To unsubscribe from this group, send an email to: DMCForum-unsubscribe@xxxxxxxxxxxxxxx Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service <http://docs.yahoo.com/info/terms/> .
<<attachment: winmail.dat>>
Back to the Home of PROJECT VIXEN