RE: [DML] Re: WANTED: Angle Drive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [DML] Re: WANTED: Angle Drive

I ran the drill starting with my lower cable, no angle drive.
This worked fine with no resistance.
My Makita runs the car at 65 MPH.
The angle drive is locked up.

To: dmcnews@xxxxxxxxxxxxxxxxxxx: joe.dalton@xxxxxxxxxxxxxx: Thu, 29 Nov 2007 16:46:31 +0000Subject: [DML] Re: WANTED: Angle Drive

Bob,Did you try to run the angle drive from the cable side with a drill, but without the hub in its place (forwards/backwards)?Did you also try to run the angle drive without and with cable from the hub side without the hub (forwards/backwards)?Results?Welmoed.--- In dmcnews@xxxxxxxxxxxxxxx, Videobob Moseley <videobob@...> wrote:>> > No, I did not replace the large nut that the drive mounts to.> I did however just have a bearing failure on that same wheel.> So who knows....could be anything.> All I know is this, nuts, cables, bearings... explain why when I try to spin these drives the gears lock up?> I suppose the drive could have been damaged by whatever was "wrong" with my car, maybe.> -VB 

[Non-text portions of this message have been removed]

To address comments privately to the moderating team, please address:

For more info on the list, tech articles, cars for sale see

To search the archives or view files, log in at 
Yahoo! Groups Links

<*> To visit your group on the web, go to:

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    (Yahoo! ID required)

<*> To change settings via email:

<*> To unsubscribe from this group, send an email to:

<*> Your use of Yahoo! Groups is subject to:

Home Back to the Home of PROJECT VIXEN

Copyright 2006  All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive