[DML] Re: Replacing tranny seals, roll pin wont budge
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[DML] Re: Replacing tranny seals, roll pin wont budge

Thanks a lot for all the help. I finally had to go get another punch 
that was exactly the right size, it popped right out! 

New issue:

The old seal is REALLY stuck. If I pry it with a screwdriver I can 
see it move a little but the edges remain adhered to the sides. I am 
going to purchase a seal puller today but even if I get it out there 
is going to be old seal stuck to the sides. What do I do in this 

Another thing: While prying at the seal I noticed the final drive 
nut move a tiiiinnny (a mm or less) bit within its keepers. Is this 
going to mess up my adjustment???

Thanks again for all the help.


To address comments privately to the moderating team, please address:

For more info on the list, tech articles, cars for sale see www.dmcnews.com

To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews 
Yahoo! Groups Links

<*> To visit your group on the web, go to:

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    (Yahoo! ID required)

<*> To change settings via email:

<*> To unsubscribe from this group, send an email to:

<*> Your use of Yahoo! Groups is subject to:

Home Back to the Home of PROJECT VIXEN

Copyright 2006 ProjectVixen.com.  All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive