Re: [DML] Starting Problem
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DML] Starting Problem



Probably on all cars, all years, all makes (with negative ground), the commonest answer
is a bad ground connection, the one from the negative cable on the battery to chassis
ground. When your car acts up, take a battery jumper cable, connect it from your
negative battery terminal to the nearest part of the chassis you can reach (I use the
alternator frame) see if that's your problem. If so, that ground connection should be at
the right rear of your D. Or do it another way, with 13 plus volts across your battery
terminals take a VOM and measure from the positive terminal to chassis ground and see if
that reads 13 plus volts. There are some far out answers like the cables themselves,
once in a great while a bad connection from the cable to the lead connector that actually
connects to the battery but those are rare and can be immediately checked with a VOM
also. You can also measure the resistance from the negative terminal to the chassis
(again, I use the alternator frame) should read about an ohm and a half, if it's more
than that be suspicious. Your battery has the proper voltage and you have a good
starter, the voltage isn't getting to it.

paulus260572 wrote:

> Hello all,
>
> The problem I'm having on starting is this sometimes when I crank the
> car over its like the battery is flat and there's hardly any reading
> on the volt gauge then all of a sudden the car will start and be fine.
>






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated