[DML] Re: Removing right door
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[DML] Re: Removing right door



WARNING! This information is incorrect and could cause serious damage to the
door hinge and mounting hardware. The torsion bar must be removed before
attempting removal of the door. (workshop manual P:02:06)

DMC Joe / De Lorean Services / <dmcjoe@xxxx>
Visit My New Web Page
<http://www.geocities.com/MotorCity/Flats/3755/dmcjoe.html>
Web Site: <http://www.deloreanservices.com>
----- Original Message -----
From: <CBL302@xxxx>
To: <dmcnews@xxxxxxxxxxx>
Sent: Thursday, January 27, 2000 1:11 AM
Subject: [DML] Re: Removing right door


> In a message dated 1/27/00 12:00:10 AM Eastern Standard Time,
> Delorean17@xxxx writes:
>
> << I dont see how
> you can pull the torsion bar out because I thought it would spin if you
did.
>
> Obviously I am not getting something. Could someone please help me out?
I
> just want my door off! by the way, my rear window was knocked out in a
car
> >>
>
> Good news for you, You DO NOT have to remove the torsion bar to remove the
> door,just unplug the door harness thru the access hole on the roof,pull
the
> harness thru after you remove the harness water seal plate(two
> screws)(p/n108599)then have the door supported or held in the fully opened
> position,remove the gas strut(caution:Make sure the door is HELD up in the
> fully open position,as you remove the strut,othewise the door will come
down
> on you,then all that is left is to remove the FOUR HORIZONTAL bolts that
are
> on the swivel part of the door hindges(The ones that go thru/hold the
doors)
> and one person on each side of the door takes it away,when installing the
new
> door make sure you DO NOT bump into the torsion bar, I have removed(and
> installed) many Delorean doors this way,and have never had any problems,as
> long as you do not remove the Torsion bar Retainer Plate(p/n 105006)the
> torsion bar will stay under torque whether the door is on the car or off
the
> car,also remember that the torsion bars,CANNOT be interchanged between
left
> or right side.
>
> Claude
> 000570






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated