[DML] Re: CO adjustment

["Mike Bosworth" <mike.bosworth@xxxxxxxxxxxxxx>]

Hi Ryan

The wire that feeds this terminal is the orange one that comes from 
pin 17 on the ECU module and is the one you measure the pulse cycle 
with when adjusting the fuel mixture ( the ECU is the silver vertical 
hanging module behind the drivers seat ). If like me your Diagnostic 
plug wiring has melted in the past on the exhaust, then you probably 
wont get a signal on it. I connected a new wire to this cable just off 
the black ECU connector, i pulled back a little of the black tape  
and 'scotch locked' it on and i now have this wire coiled up in the 
cubby hole underneath for pulling it into the engine bay for future 
use.

Any further questions please ask away :)

Regards

Mike
#2001
Yorkshire UK


--- In dmcnews@xxxxxxxxxxxxxxx, Ryan Wright <ryanpwright@...> wrote:
>
> Where does the CO adjustment wire (top right corner pin on the
> diagnostic connector) go to? I can't get any signal whatsoever out of
> it, so I want to track the wire down and make sure it isn't broken
> anywhere.
> 
> -Ryan
>








To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx

For more info on the list, tech articles, cars for sale see www.dmcnews.com

To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/dmcnews/

<*> To unsubscribe from this group, send an email to:
    dmcnews-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/