[DML] Re: Speedometer bouncing
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[DML] Re: Speedometer bouncing
- From: "Marv Hein" <marvhein@xxxxxxxxxxx>
- Date: Tue, 10 Jan 2006 21:49:39 -0000
I guess you could start by lubricating the angle drive through the
set screw or grease fitting, if you have one. There is a tech note
or recall notice around someplace on that. It's easily done from
behind the left front wheel with the wheels turned hard left. No
need to jack up the car, remove the tire, etc. If using the set
screw, disconnect the cable and flip the drive over to add
lubricant, flip back and reconnect the cable. Try to do it every oil
change. I believe the recommended lubricant on the recall notice
was gear oil because I had to go buy some to do this.
To further delay repair, it's probably not a bad idea to pull your
speedometer cables from their sheaths and inspect/lubricate them.
My lower cable slipped in and out easily when disconnected from the
AD and lambda counter. I imagine the upper will do the same, but I
am guessing since I haven't serviced it. You may find them frayed,
which could be the cause of your bouncing.
This bought me about six months of additional service before the AD
quit. I didn't notice any real difference in speedo performance
after I installed my new angle drive... still within a mph or so of
my GPS readings.
Marv
#10820
AZ-D
--- In dmcnews@xxxxxxxxxxxxxxx, Ryan Wright <ryanpwright@xxxx> wrote:
>
> Hello,
>
> At lower speeds, my speedometer bounces up and down. Any idea what
the
> problem could be? I think I recall reading a new speedo cable would
> fix this but not sure if I need upper or lower, or if there's
> something else I should look into.
>
> Thank you,
>
> -Ryan
>
To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx
For more info on the list, tech articles, cars for sale see www.dmcnews.com
To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/dmcnews/
<*> To unsubscribe from this group, send an email to:
dmcnews-unsubscribe@xxxxxxxxxxxxxxx
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
Back to the Home of PROJECT VIXEN