[DML] Re: Water in gas?!?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[DML] Re: Water in gas?!?
- From: "dmcchaser" <dmcchaser@xxxxxxxx>
- Date: Mon, 17 Oct 2005 19:18:33 -0000
I don't have a lot of experience with water in the fuel on our
Deloreans, however I am familiar with the K-Jetronic system on other
vehicles. So my two cents may be a little off.
First off I don't think you need to worry about blowing a head
gasket during the backfire, possibly damaging/bending the fuel
metering flap or blowing out a weak muffler but the head gaskets
should be fine.
From past experience I know that the fuel distributor can be very
picky about any water of debris in the fuel supply. The fuel
distributor itself is non-servicable but if you were to take it apart
the fuel metering piston (the correct name escapes me) will not fit
back into its bore with fingerprints on it. Not dirt, just oils from
fingerprints. So you see the tolerances are very fine and the fuel
supply must be clean.
If you have enough water in your fuel that it is coming out of the
injectors cloudy I would recommend draining the fuel tank completely
and starting with fresh fuel. Also change your fuel filter. I know
it's a hassle, but it's better than having to replace your fuel
distributor.
Matt Smith
--- In dmcnews@xxxxxxxxxxxxxxx, Phil Priestley <phil@xxxx> wrote:
>
> Last time I took the D out it was running well until I pulled in
to
> get gas. The tank was fairly empty so I filled it and took off
then
> about a mile later the car started hesitating like it was starving
> for fuel. I was sitting at a light and when I gave it gas to take
off
> the engine died but restarted when I turned the key. The car kept
> acting like it was starving for fuel and after a block or so it
> started running fine.
>
> Yesterday I pulled it out of the garage to take it out for a run
and
> as soon as it was in the driveway it died. I restarted it and it
died
> again. I pulled the fuel pump and verified that it was working by
> jumping the relay connectors. I finally pulled an injector and
stuck
> it in a bottle , jumped the relay again and pushed down on the air
> flow meter. The fuel that sprayed out into the bottle was a
cloudy
> and seems to have a lot of water in it. Put everything back and
> tried firing it up again thinking If I could get it running It
would
> pull the water through the system. After cranking it a couple
times
> there was one hell of a backfire but no starting. The battery was
> almost dead from all the starting attempts and It wouldn't start
with
> a jump so It was pushed back into the garage.
>
> This morning I took it off the charger and tried to fire it up. It
> starts but as soon as fires up it dies and there seems to be a
fair
> amount of water coming out of the the exhaust . I would hate to
think
> that the back fire could have blown a head gasket and they were
> changed 200 miles ago. I'm not looking forward to having to pump
out
> a full tank of gas for a little bit of water in the bottom but was
> thinking that since gas floats on water I might be able to pump a
gal
> or two out and get the bulk of it, then add a fuel drier and run
that
> tank of gas out and refill. Anyone have any ideas?
>
> Phil Priestley
>
> Vin 2105
> IN FLUX
>
> http://alessandros120.com/
> (503)370-9951
> 1(866)225-7985
>
>
>
> [Non-text portions of this message have been removed]
>
To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx
For more info on the list, tech articles, cars for sale see www.dmcnews.com
To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/dmcnews/
<*> To unsubscribe from this group, send an email to:
dmcnews-unsubscribe@xxxxxxxxxxxxxxx
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
Back to the Home of PROJECT VIXEN