RE: [DML] Won't start after ballast resistor wire broken

["John Hervey" <john@xxxxxxxxxxxxxxxx>]

One more thing. You should have about 9 to 10 volts on the blue/yellow wire
when starting. right side.
John



-----Original Message-----
From: phildadme [mailto:philwiltfong@xxxxxxx]
Sent: Tuesday, February 22, 2005 12:13 AM
To: dmcnews@xxxxxxxxxxxxxxx
Subject: [DML] Won't start after ballast resistor wire broken





My low-miles D started just fine, as always, then all of a sudden
began to shake with a really rough idle.  I shut it off and then it
wouldn't start again.  So I looked around and found that the double-
spade terminal on the right end of the ballast resistor had broken
and one wire was therefore disconnected.  I replaced it and plugged
in both wires but now I can't get my D to start at all.  Could it
have blown something?  Don't know how the ballast resistor works
with the coil so don't know what to check first.  Sure appreciate
any help to know more.








To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx

For more info on the list, tech articles, cars for sale see www.dmcnews.com

To search the archives or view files, log in at
http://groups.yahoo.com/group/dmcnews
Yahoo! Groups Links













To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx

For more info on the list, tech articles, cars for sale see www.dmcnews.com

To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/dmcnews/

<*> To unsubscribe from this group, send an email to:
    dmcnews-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/