Almost there
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Almost there
- From: "cruznmd" <racuti1@xxxx>
- Date: Fri, 18 Jul 2003 15:58:12 -0000
My Kingdom for a fuel distributor. :)
I leaned out the CO screw today, and the car definitely caught more,
but it's just too much fuel. Long after the engine stops cranking I
can -hear- gas flowing into the cylinders. It's that bad.
I can smell the fuel, especially coming out of the exhaust. I tried
adjusting the Primary Pressure Regulator but that just made it leak.
The metering plunger stuck again and only a whack from a hammer freed
it up. (Hey, the distributor is toast anyway)
I used my kids to help set the timing. I was pretty close. You should
see the way they jump around when they're holding the high tension
wire! (Just kidding)
I found the short in the oil pressure gauge. That was good.
I reset the needle in the fuel gauge. It still pegs. That wasn't so
good. I hope it's just the fuel sender and not a short in the wiring.
I'm going to stop cranking the engine until I have a new fuel distro
and pressure test kit. I'll just end up bending a rod or something.
Rich
Back to the Home of PROJECT VIXEN