RE: [DML] Re: New master clutch problem

[jwit6@xxxx]

Stainless braided is great, but solid steel line is just as good an no where near as expensive . 
Jim 6147

"David Teitelbaum" <jtrealty@xxxx> wrote:

>Sounds like you need to bleed more air out of the slave cylinder. You
>should also replace the plastic line between the master and slave
>cylinder with the braided steel one if it has not already been
>changed. You should try to use Castrol GTLMA DOT 4 brake fluid. It is
>the most compatible with the type of rubber used in the seals. 
>David Teitelbaum
>vin 10757
>
>
>
>--- In dmcnews@xxxxxxxxxxxxxxx, "bluemax86" <massimot@xxxx> wrote:
>> Hi all,
>> 
>> This is my first post to the list. I have recently replaced my master
>> clutch cylinder. Since then the pedal feels rather light until the
>> very end and there is maybe 1/2" travel between the clutch being
>> fully depressed and when it starts to engage.