Front hood corners not straight

["John Elgersma" <delorean@xxxx>]

It might just be that QAC had a heck of a job getting the panels to 
line up properly with the fascias when the car first rolled off the 
assembly line and arrived in the US. As much as you can adjust one 
side perfectly, it might not always line up correctly on the other 
side. As much as most of my rear fascia lines up pretty decent now, 
I noticed that the front corners of the hood seem to raise upward a 
little. I pressed down on them but it appears that the hood is 
perfectly flat but the fascia is slightly rounded. Anybody else ru 
into this and if so, what might have ccaused it and is there a fix 
for this??
JohnE
10250