RE: [DML] Idle speed sensor
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [DML] Idle speed sensor
- From: "John Hervey" <john@xxxx>
- Date: Sun, 18 May 2003 21:11:01 -0700
Mark, Under normal tap water and with a digital ohm meter set on the 20K
scale hooked up to the two terminals.
The reading will vary but 8,000 ohms cold and hot water 2400 ohms.
John Hervey
-----Original Message-----
From: id [mailto:ionicdesign@xxxx]
Sent: Sunday, May 18, 2003 4:52 PM
To: dmcnews@xxxxxxxxxxxxxxx
Subject: [DML] Idle speed sensor
Ok i have one sensor to test and i dont know how so i am asking for help
again. Part #102480 Idle Speed Thermister or also known as Constant Idle
Switch Thermister. This switch has 2 connection tabs on it. I hooked up a
tester and
ran it uneder hot and cold water and it didnt seem to do anything,
Back to the Home of PROJECT VIXEN