Re: RE: [DML] RPM guage sticking

[<cahamond@xxxx>]

My Gauge was stuck too. Turned out a diode was fried on the RPM Gauge's Circuit board. Tried to find a replacement board but had no luck with that... Purchased a new Gauge from DMC Houston. This solved my problem.
Chris Hammond
Vin 1882
> 
> From: Travis Goodwin <tgoodwin@xxxx>
> Date: 2003/04/29 Tue PM 01:21:15 EDT
> To: "'dmcnews@xxxxxxxxxxxxxxx'" <dmcnews@xxxxxxxxxxxxxxx>
> Subject: RE: [DML] RPM guage sticking
> 
> Have you worked behind the binnacle recently? Could be an electrical
> connection in the back, but this would be the last place I check (since it's
> such a pain to take the thing off).
> 
> > -----Original Message-----
> > From: dmcorlando2003 [mailto:SundeQuick@xxxx]
> > Sent: Tuesday, April 29, 2003 10:55 AM
> > To: dmcnews@xxxxxxxxxxxxxxx
> > Subject: [DML] RPM guage sticking
> > 
> > Every now and then when I am driving my RPM needle just freezes.
> > Sometimes it will jump a little before it freezes. Then after a few
> > seconds it starts working again. Happens at all different speeds and
> > times. Any ideas?
>