Re: [DML] Door problems too
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [DML] Door problems too
- From: "mgutkowski@xxxx" <webmaster@xxxx>
- Date: Mon, 16 Dec 2002 05:23:43 -0500
Hi Richard
I find it hard to believe the ball joint is what's squeaking - are you sure
it's not the hinge, the strut itself going bad, the lower mount having been
bent or, as I suspect, the seal that runs along the top edge of the door? I
replaced mine and the drivers one squeaks quite badly in common with a lot
of D's. If that seal has become dislodged, it may jam in the mechanism
making the door tough to close. Be careful of the torsion bar!
For everything else above, try a squirt of WD40 (which is a penetrating oil
remember people). For the strut itself: How old is it?
Martin
#1458
#4426
Original Message:
-----------------
<< Ok I'm having my first major problem with my drivers side door.
The joint where the strut connects to the door is squeaking really
badly and the door has become harder to close. I'm hoping the
strut is not ready to pop off, but what can I do right now to
tighten this up/get rid of this problem outside of buying a strut?
Is there anything?
(I need to drive my D to work tomorrow so I'm hoping it will hold
up until I can get advice and take some kind of look at this!)
Thank you as always,
Richard >>
--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .
Back to the Home of PROJECT VIXEN