Re: [DML] A number 7 fuse short circuit

[kayoong@xxxx]

There is no need to change the battery cables. I am not sure if your "high 
grade audio" means a high power amplifer. 

If you are hooking a high power amplifier of 150 watts RMS total or higher, 
you should run the amp feed wires directly to the battery by using the 
correct gauge wires, usually a #6 minimum and higher, with a fuse in line 
(series). This way the amplifier, which is placing a high electrical demand, 
will not burn up the OEM wires. A #22 gauge wires will NOT handle the 
amplifier's electrical demand. DO NOT be "wired for fire."

BTW. If you are using a high power amplifier, make sure your battery and 
especially your alternator is up to par to supply the amplifier's demand at 
full power draw and or with your A/C running. With these two units running, 
the standard OEM alternator, will not or will just barely supply the 
electrical demand, thereby shorting the life of the alternator or your 
battery. 

I am presently deciding to replacing my high powered amplifier from a JL 
Audio 300/4 to either a McIntosh MC404M, a Zapco 4.0 X, or a Sinfoni 
Amplitude 120.4X for a better sound quality as audiophile quality and not the 
"boom box" sound. 

If you need more info, email me privately not to tie up the bandwidth of the 
DML.

Kayo Ong
#5508
Lic 9D NY
------------------------------------------------------------------------------

--------------------------------------------

In a message dated 11/10/02 10:29:32 AM Eastern Standard Time, 
ttanaka504@xxxx writes:

> Also can anyone please tell me how to change + and - battery wires 
> because I am thinking to replace with high grade audio(22sq) 
> wires. And New battery wire should reduce electrical loss. 
> 
> Thank you very much for all help.
> 
> Blacknight 
> ttanaka504@xxxx



[Non-text portions of this message have been removed]