Re: [DML] Window Switches

[Soma576@xxxx]

Willy,

I used to have this problem too with the window switches. i bet your wires 
are really stiff under there, aren't they? use it to your advantage. unhook 
your switches from the white harnesses, take the console apart and get as 
much slack as possible under there. fish the harnesses to where they need to 
be and try to angle them so that they are in the best position for when the 
switch is mounted. then bend the wires at a 90 deg angle so that they make 
an abrupt turn and don't hit the underbody and push the switch up. take the 
rocker off of the switch and insert it into the console, then plug in the 
harnesses. reassemble the console, then make sure they switches are totally 
flat in their slots. once you are satisfied, put the rockers back on and you 
should be good to go!! if you try to push the switches back down with the 
rockers on you probably will not get good results since you can't tell if the 
rocker or the switch has bottomed out.

Andy