Re: [DML] Dead DeLorean
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [DML] Dead DeLorean
- From: dherv10@xxxx
- Date: Fri, 16 Aug 2002 08:24:30 EDT
Bill, You can see the picture diagram of the resistor set up on my web site
and I just posted a memo last week of the wiring diagram also on the site of
the relay that helps start the car faster. The blue yellow wire from the
solenoid is what gives you the extra voltage on the left side of the resistor
to start the car, after it starts the car runs on the white wire voltage from
the main relay that goes to the right side of the resistor. Hope this helps.
John Hervey
http://www.specialtauto.com/engine.shtml
<< No juice is entering the coil. Didn't check the resistor, but I did
jump the coil straight from the battery post. Using a timing light
determined no juice is leaving it. Electronic ignition module is next
in line -- where's it located, and what is the test procedure? Could I
just ground the coil and test for output?
>>
Back to the Home of PROJECT VIXEN