RE: [DML] Memphis AC problem

["Marc A. Levy" <malevy@xxxx>]

Id be VERY CAREFUL with this. Drill in the wrong place, and you could drill though your heater core or AC evaporator.

Have you tried a shop vac on the end of the drain hose?


> -----Original Message-----
> From: Delorean17@xxxx [mailto:Delorean17@xxxx]
> Sent: Wednesday, June 19, 2002 8:04 PM
> To: dmcnews@xxxxxxxxxxxxxxx
> Subject: [DML] Memphis AC problem
<SNIP>
> Everything was fine until my AC drain line got plugged 
> up(again). When 
> I came home I removed both seats and carpet sections before 
> it started to get 
> musty in there. I can unclog the drain with compressed 
> air but then it 
> clogs back up within and hour. I talked to Don Steger in 
> Memphis and he said 
> that it can be fixed without removing the entire box. He 
> said to buy a 2 
> inch hole cutter and cut out a hole in the bottom of the evap 
> box so you can 
> reach in and remove all of the junk. I think I might do this 
> tomorrow but 
> before I start I need to know where I should drill this 2" 
> hole... I don't 
> want to cut anything inside the box. Has anyone on the list 
> performed this 
> operation? Any info would be greatly appreciated.
<SNIP>