Re: Mid_Atlantic Spring Social

["jtrealtywebspannet" <jtrealty@xxxx>]

All three brass screws should be lighly seated closed by turning 
clockwise but the only one that really matters is the lowest one with 
a cut in the head for a screwdriver. The other two can usually be 
found open all the way but if the first is closed since it feeds the 
other 2 then they don't matter.
David Teitelbaum
vin 10757



--- In dmcnews@xxxx, "DMC Joe" <dmcjoe@xxxx> wrote:
> Steve,
> 
> All three brass screws should by turned clockwise. It is not 
necessary to
> make the screws tight.

> ----- Original Message -----
> From: "dmcman82" <dmcman73@xxxx>
> Subject: [DML] Re: Mid_Atlantic Spring Social
> >
> > Where should the Brass screws be adjusted too? Seated in or seated
> > out? Or is this an adjustment that requires special tools?
> >
> > Steve