Re: [DML] Re: Coils

[jwit6@xxxx]

In a message dated 2/18/02 3:59:05 PM Eastern Standard Time, wingd2@xxxx 
writes:

<< The "fix" I used on my turbo car was to install an aftermarket high 
performance coil. I chose an "Accel #8140" coil. This unit is a direct 
replacement that will even fit the original mounting bracket. It is a "plug 
and play" type part and requires no additional wiring or parts. >>

Marty,
With the Accel coil is it necessary to keep the ballast resistor and relay 
wiring, or can I run it at a full 12 volts all the time? I'm in the middle of 
an engine compartment wiring purge and I'd like get as much of the 
unnecessary wiring out as I can.
Thanks,
Jim