fuel pressure tester

[Noah <sitz@xxxx>]

<question value="newbie">

OK, so I have the NAPA fuel pressure tester for Bosch K-Jetronic systems
hooked up to my fuel system. Except jumping the RPM relay only shows like
20 PSI, and since the car runs fine, I'm assuming I'm being a tardmonkey.
The connection currently runs:

Fuel distributor -> gauge (balljoint side) -> pressure regulator

although I also tried it reversed, and with the little lever on the gauge
in both positions.

All connections between the car and the gauge are handled using adapters
which have no O-rings, which matches the (rather sparse) sheet that came
with the gauge. I let the fuel pump run for 30-60 seconds or so, and never
break 20 PSI. Suggestions? Comments? Canned laughter?

I'm also on AIM <sitzkrieg9> today, in case one of you clueful types is
around. Thanks. :)

Noah
#2867

Impossible, sir. It's in Johnson's underwear.