New exaust system (was stainless steel air filter box)

["Walter" <Whalt@xxxx>]

John Hervey,

Do you want to volunteer to make a new exhaust system? (No sarcasm
intended.) Making curved round stainless pipes requires different tools
than angular shaped air boxes. I'm familiar with the later. Each time I
check my stock air filter, I hate putting it back in when I would rather
replace it with a K&N. Since the exhaust system is maintenance free, I
don't think about it as often.

There is a sadly rusted out DeLorean frame with what is left of an engine in
town that I might buy from the owner. (All of the valuable parts have
already been scarfed off.) Having that to get dimensions from, I might try
to design a better exhaust IF I can get someone to make it for me. If I
showed up to an exhaust shop with some tubes of 18-8 stainless steel, would
that be too hard on the bending equipment?

Walt Tampa, FL
-----Original Message-----
From: dherv10@xxxx <dherv10@xxxx>

>Walt and others, Why do a lot of work on the intake end, when your
>just going to run into a problem on the exhaust end.