Re: co mix screw

[jtrealty@xxxx]

It is an metric allen screw but before you go turning it put some tape 
or a plastic plug in the opening and see how it works. To properly 
adjust the mixture screw you need an exhaust analyzer.
David Teitelbaum
vin 10757



-- In dmcnews@xxxx, Delorean17@xxxx wrote:
> Hello,
> I have been working on my project car for some time now and 
havent been 
> able to figure out its odd idle and poor acceleration problems. The 
frequency 
> valve is working properly so I thought the problem may be related to 
the 
> intake system.
> I thought it might be a good idea to check the co levels and 
adjust the 
> screw as necessary. I removed the intake(both halves) and found 
that the 
> metal ball(plug) that covers the hole was missing(nice sized vacuum 
leak I 
> guess). It also looks like the screw is in as far as it can go. I 
am 
> guessing this could be my problem although I dont know for sure. 
Where can I 
> buy one of these plugs at? also, what type of head is on the co mix 
screw? 
> you cant really see it through that little hole.
> 
> Thanks
> David