Re: [DML] back firing, no start
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [DML] back firing, no start
- From: dherv10@xxxx
- Date: Mon, 16 Oct 2000 23:45:12 EDT
David, Didn't you have the distributor out. If so you need to re establish
TDC with #1 cyl piston at the top and re stab the distributor two #1. If not
then loosen the bolt that holds down the distributor and turn it a few
degrees either way. When it trys to start then you know your going the right
way. If you run out of turning, due to plug wires. Then it's a re stab. It's
just out of sink with TDC or so far to out of alignment.
John
Back to the Home of PROJECT VIXEN