Re: [DML] No Air Conditioner
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [DML] No Air Conditioner
- From: "Dave Sontos" <dsontos@xxxx>
- Date: Thu, 14 Sep 2000 20:15:31 -0400
Dale,
92 psi is the correct rest pressure for an R12 system. Your problem is in
the electrical side of the AC system. If you run a #12 jumper wire from the
battery to the single pink wire on the compressor, this will energize the
compressor clutch and run the compressor. Once you've determined that the
compressor is working, work back through the electrical harness to where it
goes through the firewall, I don't remember which color connector is the AC
connector, work some WD40 in the connector terminals. Next check the low
pressure switch behind the right front wheel and clean those contacts with
WD40.
That usually cures any AC electrical problems.
Dave Sontos
VIN 02573
----- Original Message -----
From: "Dale Schaub" <daleschaub@xxxx>
To: <dmcnews@xxxxxxxxxxx>
Sent: Thursday, September 14, 2000 1:45 AM
Subject: [DML] No Air Conditioner
> My air conditioner just quit working. The pressure is the same at both the
> low pressure side and high pressure side at 92 psi. I do not hear the A/C
> cycling as I normally did. Any ideas?
>
> Dale Schaub
>
>
>
> Before posting messages or replies, see the posting policy rules at:
> www.dmcnews.com/Admin/rules.html
>
> To address comments privately to the moderating team, please address:
> moderator@xxxx
>
Back to the Home of PROJECT VIXEN