Re: Summer Heat, now hard starting Q
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Summer Heat, now hard starting Q
- From: "Robert Rooney" <dmcvegas@xxxx>
- Date: Sun, 13 Aug 2000 02:28:05 -0000
In a way I'm kina glad to hear about this; it means I'm not the only
one! I've been having the exact same problems that you have, but
thought that it might be due to other factors on my engine. Warm
temps in spring time: no problem. Summer heat: hard starting. If
you're out some place and you need to leave in a hurry, swapping the
cold start valve & the control pressure regulator plugs will get you
going in a hurry. Now for the interesting part! If you turn to
section D:01:15 of the workshop manual under Electrical Circuit
Function, the last paragraph reads (bad punctuation included):
"The car is wired for a hot start relay. This relay can be installed
if a hot starting problem is experienced in excessively hot regions
of the country. When this relay is used is used, the cold start valve
will inject intermittently durring cranking when engine is hot."
If anyone here knows how/where to install this relay, let us know. It
would definately same me a bit of embarassment in the parking lot!
In the mean time replacing the air filter, and removing the air inlet
valve in the summer months will allow the engine to breath alot
easier. Plus a tune up wouldn't hurt. Pep Boys sells some high
performance wires that are a perfect fit, plus you can get one of the
improved ignition coils there as well. If you also decide to change
the distributor & rotor cap, DO NOT USE A CROSS-OVER PART!!! Borg-
Warner has a distributor cap that fits, but the OEM unit by BOSCH
that DMC Houston sells is a heavier, sturdier unit. The BW is
thinner, and just seems "cheaper" in comparison. Plus for daily
driving, the pick-up line in the fuel tank can give you problems. In
traffic it can collapse causing the engine to lug. If you get below
1/8 tank it can starve the engine totally. And if they aren't working
properly, a new set of ballast resistors as well. All of these items
will help make for easier starting, plus will improve performance!
Lastly, buy a sun shade from DMC Houston, they are worth every dime!
It not only saves your dash, but will keep the intierior reasonably
cool (compared to the outside).
-Robert
vin 6585
--- In dmcnews@xxxxxxxxxxx, "Chris Coplen" <blarness@xxxx> wrote:
> I recently threw my D on a trailer and moved from Grand Rapids, MI
(cloudy, and mild temps) to Austin, Texas (102 degree big, flaming
ball in the sky that just won't quit).
>
> My DeLorean has NEVER had a starting problem ever. The first time
I started it in Austin it took five long cranks and then finally
sputtered to life and ran poorly for the first minute. This
continues now EVERY time I try to start it when its hot out. And,
well, it's been triple digit temps all eight days I've been here.
>
> I, at first, accounted it as vapor lock but it does it even when
the engine is cold. Then I thought maybe it's the Michigan gas, our
votility levels are different than Texas due to our "unpredictable",
and colder weather conditions. So, late last night I threw a fresh
tank of premium in and gave her a few high speed rips up and down I-
35 but I haven't had the chance to drive it today.
>
> What would cause such a DRASTIC change in it's personality just
because I moved into a hotter environment, and what can be done about
it? Thank you.
>
> Chris
> GIGAWAT
> #3876
>
>
> [Non-text portions of this message have been removed]
Back to the Home of PROJECT VIXEN