Re: [DML] Coolant fluid
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [DML] Coolant fluid
- From: Hank Breer <hbreer@xxxx>
- Date: Wed, 02 Aug 2000 02:11:49 -0700
Sacha,
The antifreeze/water ratio should not cause your overheating problem. Most
likely, it is caused by air trapped in the cooling system. There is a
natural high point pocket above the thermostat and a brass fitting on it to
allow you to bleed the air out. Check the archives for the procedure.
If your coolant was low once, you probably have a leak in the system and
before you drive too much, you must find and correct it. There are a large
number of short hoses in the cooling system loop (and twice as many hose
clamps) and at least one is probably leaking.
The original maintenance schedule called for the coolant to be drained and
replaced every 15,000 miles. If you don't know when it was done last, it
probably should be done as soon as you are sure you have fixed the leak.
After you have drained and refilled, remember to bleed the system again.
Hank Breer
VIN 1141
Back to the Home of PROJECT VIXEN