Re: [DML] microswitch and idleing

["Dave Sontos" <dsontos@xxxx>]

Try adjusting your CO to a more richer setting. This will get your engine to
idle and then you can work on the other problems.
Dave Sontos
VIN 02573
----- Original Message -----
From: <Delorean17@xxxx>
To: <dmcnews@xxxxxxxxxxx>
Sent: Thursday, July 20, 2000 3:39 PM
Subject: [DML] microswitch and idleing


> Hello,
> I finally got my car running again after it stalled in the street last
> week. My car will only stay running when the full throttle
microswitch(parts
> manual 2/3/0 #15) is depressed. When I bought my car there was a bread
tie
> around it keeping it pressed in. when the car is running and you take the
> bread tie off, the car will go to a VERY low idle and the car will shake
and
> eventually die out.
> Why does it go down to such a low idle? The microswith triggers the
> acceleration enrichment circuit, right? I can here it start to buzz when
I
> press the switch down. any ideas on how to get my car to idle correctly.
It
> idles pretty high with the switch on all the time. the car will not be
> driven for a few more months But I would like to get this figured out.
>
> Thanks in advance
> dave
> #2496-carpet goes in soon.
>
>
>
>
> Before posting messages or replies, see the posting policy rules at:
> www.dmcnews.com/Admin/rules.html
>
> To address comments privately to the moderating team, please address:
> moderator@xxxx
>