RE: [DML] Angle Drive

["Rodger Vannatter" <rivwindance@xxxx>]

Gary,
I have similar problems and this is what I found (this may or may not be
your problem).
1. Bottom clamp on lower cable connecting to the angle drive was found to
work but was loose when holding the cable and turning it from the tip. The
clamp had become loose and was not secure on maintaining only the interior
spinning.
2. The dust seal in the outer wheel-side was distorted and not maintaining
the square design, therefore, not stablizing the inter core of the lower
unit. Replaced and it worked find.
Hope your problem is this simple and that this helps.
Rodger vin 6962


> 
> 
> Before posting messages or replies, see the posting policy rules at:
> www.dmcnews.com/Admin/rules.html
> 
> To address comments privately to the moderating team, please address:
> moderator@xxxx
> 



--- Rodger Vannatter
--- rivwindance@xxxx
.