Re: [DML] cluch

["DMC Joe" <dmcjoe@xxxx>]

Yes Archie, you have discovered one of the many items that were left out of
the workshop manual. Fortunately this is a simple step.
Remove all of the bolts that connect the intimidate drive shaft (parts
manual 4/7/0 #3) from the transmission driveshaft flange (#2). Once
disconnected use bailing wire or cord to tie both driveshafts up and away
from the transmission.

One other note: You will need to jack up the engine appox. 1 1/2 inches to
access the bolts that attach the flywheel protector plate to (parts manual
4/1/1#16) the lower section from the bell housing.

"We're here to help you"
DMC Joe / De Lorean Services / <dmcjoe@xxxx>
Web Site: <www.deloreanservices.com>
.

----- Original Message -----
From: Archie G Hill <ahelio1@xxxx>
To: <dmcnews@xxxxxxxxxxx>
Sent: Monday, May 22, 2000 2:54 PM
Subject: [DML] cluch


> may be some one can help me . I need to replace my cluch . I have the
> parts. My question is the manual does not address the axles . it tells
> how to remove the trans. but does not say anythingabout what to do with
the
> axles. Thank you in advance.
>
>
> Archie hill
>
> vin 05395