[DML] 3rd Brake Light Wiring

["Mike Walsh" <yahoo@xxxxxxxxxxxxxx>]

Hi Everyone. I purchased a 3rd brake light from a GM dealer (from '86 
Vette) and was trying to figure out how to run the wires to splice 
into the taillight. 

The light will sit on the top louver and the wires will go through a 
small hole to run forward into the rear screen (the part you remove 
to adjust the torsion bars). I have a small mail/female connector 
which I was going to hide just inside the light housing. That way if 
the louvers have to come off it would be simple to disconnect. From 
the light the wire is a smooth black (18/2) cable about 1/4" in 
diameter.

Any suggestions on where to run the wire from there? I have not had 
the t-panel off so I am not sure the best way to get it to the tail 
light. I am guessing that finding a ground is no problem but I am 
open to suggestions on that too.

- Mike
#17084




To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx

For more info on the list, tech articles, cars for sale see www.dmcnews.com

To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/dmcnews/

<*> To unsubscribe from this group, send an email to:
    dmcnews-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/