[DMCForum] Re: Cupholders

["Joe OBrien" <joeyoseppijoe@xxxxxxxxx>]

Nice ides, but with Delorean specific cupholders available, and the 
time involved, maybe a bit on the crazy side.

Plus most all homemade cupholders look so damn trashy, they detract 
from the appearance of the car.

Just my $0.02


-Joe



--- In DMCForum@xxxxxxxxxxxxxxx, "Mike Walsh" <mike@xxxx> wrote:
> Maybe it is a little extreem but I was thinking of building one 
out of
> stainless - but here's the thing, I wanted to mount it using a 
part from
> stainless countertops.
> 
> If you look at some stainless table tops at fast food resturants, 
you might
> see a fitting on the surface. They are a little bigger than a 
quarter and
> have a spring loaded center.
> 
> 2 of these fittings could be mounted next to the shifter on the 
passenger
> side. With out the cup holder they would look like a couple of 
stainless
> buttons.
> 
> The cup holder would have a U shapped bracket made out of 2 
quarter inch
> tubes (solid or hollow). To mount the cup holder just positon each 
tube over
> the spring loaded button and let it drop inside (you might have to 
reinforce
> the plastic from underneith). It would make it easy to put on and 
take off.
> 
> Am I crazy or does this make any sense?
> 
> Mike Walsh
> #17084

---

YAHOO! GROUPS LINKS

•  Visit your group "DMCForum" on the web.
   
•  To unsubscribe from this group, send an email to:
   DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
•  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---