[DMCForum] Re: Angle torque 75 degrees = ? ft *lbs
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[DMCForum] Re: Angle torque 75 degrees = ? ft *lbs




I fudged it by marking 75 degrees with a marker on the actual socket.
Then I aligned it with a reference point on the crankcase and turned
it until it lined up with the 2nd mark.  Seemed to be around
65-70ft*lbs when I was done.

Matt
#1604


--- In DMCForum@xxxxxxxxxxxxxxx, Martin Gutkowski <martin@xxxx> wrote:
> Angle torquing eliminates any variation in the "slipperiness" of the
> nut/thread. That's why it's used
>
> Martin
>
> Matt Spittle wrote:
>
> >
> > Anyone know a rough equilvalent of angle torquing 75 degrees in
ft*lbs?
> >
> > This is for the main bearing cap nuts.
> >
> > thanks,
> >
> > Matt
> > #1604
> >





Yahoo! Groups Links



Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated