Re: [DMCForum] Re: It's Official -- Fuel Injection Sucks (Greg)

[Andrei Cular <acular@xxxxxxxxxxxxxxx>]

And if you pull the 2 air hoses you have a direct shot at it, with room 
for 2 caps to x-fer the wires.


Andrei

content22207 wrote:

>Nope -- this is what mine looks like:
>
>http://bjoern.brembs.net/cars/engine.jpg
>
>I think there's a distributor in there somewhere...
>
>Bill Robertson
>#5939
>
>  
>
>>--- In DMCForum@xxxxxxxxxxxxxxx, "timnagin" <timnagin@xxxx> wrote:
>>Bill,
>>
>>As I mentioned before, this is a very simple system and I have no
>>    
>>
>doubt you
>  
>
>>can understand how it works by nothing more than looking at it.
>>
>>This should be what your engine looks like, right?
>>
>>http://mustangandfords.com/howto/p63288_image_large.jpg
>>
>>If the throttle is in the way of removing the passenger side valve
>>    
>>
>cover,
>  
>
>>you should be able to remove the throttle assembly fairly easily.
>>
>>If you need to get the whole plenum out of the way, doing so will
>>    
>>
>give you
>  
>
>>this much room.
>>
>>http://mustangandfords.com/howto/p63327_image_large.jpg
>>
>>It really is a very simple system, like the GM TPI is as well.
>>
>>Greg
>>
>>
>>
>>
>>-----Original Message-----
>>From: content22207 [mailto:brobertson@xxxx]
>>Sent: Tuesday, December 21, 2004 11:35 PM
>>To: DMCForum@xxxxxxxxxxxxxxx
>>Subject: [DMCForum] It's Official -- Fuel Injection Sucks
>>
>>
>>
>>
>>I am in DC to take final possession of a new to me truck that has
>>apparently never been subjected to the rigors of routine maintenance
>>(the vehicle I was slam shifting around New Jersey last month).
>>Decided to start with ignition (cap/rotor/wires/plugs). Ford Motor
>>Company has absolutely ruined the 302 with EFI. What should have taken
>>less than a half hour consumed most of my afternoon. The distributor
>>is still right up front, where it always has been, but now has a
>>gigantic air plenum covering it up. Covers the water temp sender too.
>>And the PCV valve. Ever thorough, Ford decided to wrap the plenum over
>>the passenger valve cover as well, which in my case is leaking and
>>needs a new gasket. It's Douvrin all over again...
>>
>>Which way to the nearest cast iron manifold?
>>
>>Bill Robertson
>>#5939
>>    
>>
>
>
>
>
>
>
> 
>Yahoo! Groups Links
>
>
>
> 
>
>
>
>
>  
>

Yahoo! Groups Sponsor

Get unlimited calls to

U.S./Canada

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.